Saturday, March 31, 2012

Loose cavity inner undercut release method in injection Molding

›
one way to release the undercut is to loose cavity, the opposite of loose cores, loose inner cavity is used to remove the undercut in the ...
13 comments:

Loose core for ejecting undercut at injection mold

›
Picture above shows the loose core, or often also called slope ejectors or inclined pin, loose cores is one method to overcome ...
6 comments:

using mold base become locking block of slider unit

›
moldbase sometimes can be used for the locking block on the slider unit, this is basedon several reasons, for example, to reduce cost,...
3 comments:

runner components of injection mold

›
Runner components between the two mold plate and three plate mold because there are different functions of these components, but there are...
5 comments:

Lifting bolts hole design in injection mold

›
Plate transfer process occurs during the machining and assembly of mold, both for the cavity and mold base plate, especially for the pla...
12 comments:

Runner Design in Injection Mold,

›
in designing the runner, first-time we must consider items that affecting  runnersize, some of which - Volume of part, the greater the vol...
1 comment:

Injection Mould Venting System, a little part of design that have big effect on part quality

›
venting is a small part of the mold design , on the design process also requires a very short time , perhaps only 10 % or les...
17 comments: